EPES | ECO-PROCESS ENGINEERING SYSTEM FOR COMPOSITION OF SERVICESTO OPTIMIZE PRODUCT LIFE-CYCLE
01-09-2011
-28-02-2015
01-09-2011
-28-02-2015
01-10-2011
-30-09-2014
01-10-2011
-30-09-2014
01-09-2010
-28-02-2013
Nikon K-CMM Metrology - By positioning LEDs on the robot end effector, and on the target parts, the K-CMM system can measure relative positioning to a very high degree of accuracy even over large distances.
Siemens TIA Portal, WinCC, PLCs – The lower level control of resources in the system was performed with Siemens brand programmable logic controllers
Nikon Adaptive Robotic Control (ARC) – this technology allows data from metrology systems to correct a robot controller’s coordinate system and compensate for inaccuracies and variability.
KUKA Robotics – Compatible with the ARC system, the KUKA robots were used for part positioning.
Nikon K-CMM Metrology - By positioning LEDs on the robot end effector, and on the target parts, the K-CMM system can measure relative positioning to a very high degree of accuracy even over large distances.
Siemens TIA Portal, WinCC, PLCs – The lower level control of resources in the system was performed with Siemens brand programmable logic controllers
Nikon Adaptive Robotic Control (ARC) – this technology allows data from metrology systems to correct a robot controller’s coordinate system and compensate for inaccuracies and variability.
KUKA Robotics – Compatible with the ARC system, the KUKA robots were used for part positioning.
01-01-2001
-01-01-2001
01-10-2013
-30-09-2017
01-11-2015
-31-10-2017
01-09-2013
-31-08-2016
01-07-2010
-30-06-2013